Planning an Experiment

Planning an experiment allows specification of expected runs and their property values for each step in your process. The Plan Experiment tab can be accessed by clicking on "1. Plan Experiment" in the bottom panel of measure mode. Adding runs and entering property values can be performed in the same manner as in each other tab of measure mode.

Screen_Shot_2017-09-12_at_8.06.46_AM.png

Planned runs on a step can be connected and propagated to other steps without the need for resource assignment. Assignment of planned resources is currently not supported in the plan experiment tab.

Property values entered in the plan experiment tab will overwrite the target values listed for a property in design mode. This allows for specification of runs which will have different target values from the norm. This is especially useful when performing multi-factor DOEs. Only single valued data can be entered in the plan experiment tab - multi valued data is currently not supported.

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request